- Before entering the workplace, all employees must check whether their clothing meets the requirements of the job. Slippers, high heels and clothes that affect work safety are absolutely not allowed. If they need to keep long hair to wear a helmet, they need to maintain the correct qualifications and have enough spirit to cope with the work. If they find that they are unwell, they need to leave their jobs immediately and report to the leader. During the operation, they concentrate, chat is prohibited, and they need to cooperate with each other. Operators are not allowed to operate in a state of irritability and fatigue, and safety accidents occur.
- When changing the mold, the power should be turned off first. In the case of a punching machine, the installation and debugging of the mold should start before the moving parts of the punching machine stop running. After the installation and debugging are completed, move the flywheel by hand to test punch twice, check whether the upper and lower molds are symmetrical and reasonable, whether the screws are tightened, and whether the position of the edge pressing ring is reasonable.
- When leaving get off work, the power should be turned off, and the finished products, edge materials and debris on the job should be sorted out to ensure the cleanliness and safety of the working environment.
- You must wait until all other personnel leave the mechanical working area and take away the debris on the workbench before you can start the power and start the machine.
- After the machine tool is started, one person is allowed to transport materials and perform mechanical operations. Others are not allowed to press buttons or foot switches, and it is strictly forbidden to put hands into the mechanical working area or touch the moving parts of the machine. When the machine is working, it is forbidden to put hands into the working area of the slider, and it is strictly forbidden to pick up and put parts with hands. When picking and placing workpieces in the mold, tools that meet the requirements must be used. If the machine is found to have abnormal sounds or failures, it should be turned off and checked immediately.
- Before the machine works, it is necessary to check whether the moving parts are full of lubricating oil, then start and check whether the clutch and brake are normal, and the machine tool will run idle for one to three minutes, and mechanical failures are strictly prohibited.
- The above are the relevant steps for CNC hardware processing. Operators must abide by them consciously. Illegal operation is not required. When a fault occurs, they should cooperate with maintenance personnel for repair. In the event of an accident, the power supply should be cut off immediately, the site should be maintained, and the relevant leaders should be reported for handling. If the consequences of violating the operating procedures are found, the relevant parties shall bear all consequences.
